Publicidad
Idiomas disponibles
Idiomas disponibles
REP
SN:uvwxyz
- - - - - - - - - - - - - - -
Road . . . . . . . . . . . . .
(Page 2: Type, Code, Busy, Lock Management)
Type: P Cod:001
- - - - - - - - - - - - - - - -
Busy: 10 s
Lock Rel.: S-00 s
(Page 3: Call time, number of lines, Buzzer
Call:03 s
Lines: 1
Buzzer: 2
level)
(Page 4: T1 and T2 key code assignment and
Key
1:0000
Key2: 2:0000
Password: 9998
Language: English
Password)
− Program all the parameters using the
alphanumeric keys, the ←.and.→ keys to move,
the ↵ key to confirm, the 'sp' key to switch
between the pre-established options.
− Press the → (or ←) key several times to move to
<Names>
<Lock release>
<Program>
<Cancel><Exit>
the following page
− Position the cursor on 'Program' and press ↵..
The terminal writes the data set in the memory
of the Module and displays the result of the write
operation.
− Move to the page with the <Exit> option, position
the cursor on this and press ↵. At this point
(and ONLY at this point), the Call Module will
exit Maintenance status and return to normal
operation.
− Disconnect the programming cable and switch off
the terminal pressing the 'OFF' key for at least 3
seconds or if other call modules connected to the
system are to be programmed, repeat the steps
described above.
DS1038-030
Note: Terminal Ref. 1038/56 can be set up only
for English, Italian, French, Spanish and
German.
LOCAL PROGRAMMING VIA KEYBOARD
It is possible to access programming in 2 ways:
a) If the configuration access password is
known (the password is factory set to '9998 '),
enter '00' followed by the 4-digit password and
the 'Call' key. If the password is incorrect, the
following message is displayed:
INCORRECT
PASSWORD
After the third unsuccessful attempt, entry of
the password is blocked for a period of time
that depends on the number of unsuccessful
attempts:
. No. unsuccessful
attempts
.
1.
.
.
.
3.
.
4.
.
5.
.
6.
.
•
•
255
b) If the password is not known, open the
Sinthesi S2 frame and press the programming
button (4).
After inserting the correct password – or
after pressing the programming button (4)
– the following message is displayed for a few
seconds:
v1.0B
N.S.uvwxyz
The first indication refers to the SOFTWARE
version (in this case 1.0) and to the maximum
number of programmable lock release codes:
240 (letter 'B' is displayed). These are followed
by the date of the version and the serial number
of the device (S/N) ('uvwxyz') coinciding with
the serial number indicated on the rear label
(this information makes it possible to check the
serial number WITHOUT opening the Sinthesi S2
frame).
Wait time before
new password insertion
-
-
-
1.minute
.minutes
3.minutes
•
•
252 minutes (above 4 hours)
23/03/99
7
Publicidad
