Publicidad
Idiomas disponibles
Idiomas disponibles
76 I EN
30º
GUIDE BAR
In order to prevent partial wear of the rod, reverse periodically.
The bar rail should always be square drought. Check the wear track. Place a ruler on the bar and
outside the tooth. If there is a separation between these parts, the rail is under normal conditions.
On the other hand, if there is no separation between these parts, the rail is worn. In this case, it is
necessary to repair or change the guide bar.
ADVERTENCIA
This machine has been equipped with the following recoi/chain bar combinations
Separation
Without
separaction
Tooth length
Angle of filling
85º
Angle of the side plate
60º
Cutting angle of the
upper plate
Rule
Bowed string
Publicidad
