Publicidad
Idiomas disponibles
Idiomas disponibles
8.3 Shutdown
• Move the throttle lever to the low speed
position.
• Press the ignition button until the engine
stops.
9. Chemical tank filling
WARNINGS!
BEFORE USING THE CHEMICAL SPRAYER,
YOU MUST TEST THE TANK WITH RUNNING
WATER. If you find any leaks or malfunctioning
parts, repair or replace them before using any
chemicals.
• When the liquid is added, the motor does not
have to stop, but it must be at a low speed (in
the minimum acceleration position).
• Keep the valve on the spray lance closed.
• Determine the proper amounts of concentrated
chemical and water to prepare the product mix
to be sprayed. The ratio is indicated on the label
of the concentrated chemical container.
• Remove tank cap and make sure filter (A) is
in place.
• Pour the proper amount of mix into the
tank, after pouring keep the container upside
down for a minimum of 30 seconds to empty
completely.
• Do not exceed the limit marked on the tank.
• Close the lid of the tank and make sure it is
completely sealed.
• Regulate the flow of the solution and the
scope of spray according to your needs.
10. Spraying
• Chemical spraying should be done in cool
weather with little wind. For example, first thing
in the morning or late in the afternoon. This
reduces evaporation and drift of chemicals as
well as improve product application.
(A)
• Put on all personal protective equipment
before (Page 13 ) carrying equipment on your
shoulders.
• Place the equipment on a table that support
its weight, so that the shoulder straps are off
the edge of the table.
• Put your shoulders through the straps and
secure the equipment to your back.
• Adjust the throttle lever to make the engine
run.
Turn to close
• Open the valve on the handle to start spraying.
• After opening the valve, keep the handle
moving so that the spray does not concentrate
in one spot and it could cause chemical
damage.
• Remember that the operator must face into
the wind.
• While spraying, the spray lance should swing
continuously between left and right to increase
spray range. Huge steps must match the
oscillation speed.
20
Nylon pump
PL2500N
When the engine starts and
the pump is sucking
When is
necessary
START
to spray
at low
pressure
HERBICIDE
INSECTICIDE
Normal spraying
Brass pump
PL2500L
LOW
When is
necessary
to spray
at low
pressure
When high
pressure
is required
HIGH PRESSURE
When high
pressure
is required
Publicidad
