Publicidad
Idiomas disponibles
Idiomas disponibles
13. Trouble shooting
13.1 Engine trouble shooting
Problem
Equipment
• Stopped pressing the fuel
doesn`t start
injection pump
• Water mixes with fuel
• Deterioration or carbon deposit
of the spark plug
• Lack of contact between the
spark plug and the lead wire.
• The choker is not in the fully
Equipment starts
open position
but doesn`t run at
• Incorrect fuel ratio
high speed
• Water in the fuel
• The air filter is dirty
The
equipment
• The outlet of the cylinder and
works
but
has
muffler has a carbon deposit
low efficiency
• Worn piston, piston ring and
cylinder
• The equipment is out of fuel.
The equipment
• The spark plug wire is loose.
stops while
• The filter is clogged.
operating
• There is water in the fuel.
• The vent hole in the tank cap is
clogged.
13.1 Spraying trouble shooting
The liquid
• Inlet and outlet valve are blocked
doesn`t come
• Ther is damage on the water
out
seal
• Ther is damage on piston
•Regulated
Pressure is not
enough
enough
• Inlet and outlet valve are blocked
• The elastic force of the
regulating spring is not sufficient.
• The regulating pressure valve is
worn.
• Worn piston
Pression is
• Piston working distance is not
enough but not
enough
the spraying
• The outlet and inlet valve are
worn.
•Clogged spray lances
•The holes in the spraying nozzle
The spraying mis
are worn out.
is uneven
• The spraying parts are clogged.
NOTA: Bellota reserves the right to make changes to machines and manuals without notice.
Posible cause
pressure
is
22
Solution
• Press continuosly
• Replace the fuel
• Replace the plug
• Change the spark plug
• Open position completely
• Replace fuel
• Replace fuel
• Check and clean
• Remove the carbon
• Replace
• Add fuel
• Check the wire and replace.
• Clean the filter or replace.
• Replace the fuel.
• Clean the vent hole.
• Clean or replace
• Replace
• Replace the piston
not
• Open the valve, replace or clean
• Replace all parts
•Replace all worn parts and clean
lances
• Replace them and thake it to an
authorized center.
• Clean the parts.
Publicidad
