Publicidad
Idiomas disponibles
Idiomas disponibles
c)
Unplug the unit before making adjustments, changing accessories, or putting
it away. This precaution reduces the risk of accidental start-up.
d)
Keep the unit in good working condition. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the unit). If damaged,
have the unit repaired before use.
e)
Keep the unit out of the reach of children.
f)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
g)
To ensure the designed operational integrity of the unit, do not remove
factory-installed covers or loosen screws.
h)
When transporting or moving the unit from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the unit is used.
i)
Avoid situations in which the machine stops under heavy loads during
operation. This can cause overheating of the drive elements and consequent
damage to the equipment.
j)
Do not move, shift, or rotate the machine while in operation.
k)
Do not leave the unit switched on unattended.
l)
Clean the unit regularly to prevent permanent dirt build-up.
m) The provided value of vibration emission is measured according to the
standard measurement methods. The value of vibration emission may
change if the unit is used under different environmental conditions.
n)
Before each use, make sure that the nozzle is properly mounted in the
machine and that the hose is properly attached and undamaged.
o)
Do not obstruct the air inlet or outlet.
p)
The unit is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
q)
Do not start up an empty unit.
r)
Do not tamper with the unit to alter its performance or design.
s)
Keep the unit away from sources of fire and heat.
t)
Do not overload the unit.
u)
Do not block the ventilation openings of the unit!
v)
Use of the pump to pump saltwater, corrosive substances, flammable liquids,
etc. is prohibited.
w)
Add oil to the proper level before turning on the machine. If the oil level is
too low the engine will not start or may shut down. Running an engine with
too low engine oil level may cause it to fail.
x)
Report any leakage of operating oils from the machine to the relevant
authorities or comply with the legal requirements in your area of use.
y)
Danger! Health hazard and risk of explosion of the combustion engine.
EN
Publicidad
