EINHELL Axxio 18/115 Q Manual De Instrucciones página 13

The equipment is allowed to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user/operator and not
the manufacturer will be liable for any damage or
injuries of any kind resulting from such misuse.
4. Technical data
Motor power supply: ............................ 18V
Rated speed: ............................8500 RPM (min
Max. wheel diameter: ................... 4-
Grinding wheel: ............................ 4-
................................................. (115 x 22 x 6 mm)
Cutting wheel: .............................. 4-
................................................. (115 x 22 x 3 mm)
Mounting spindle thread: ....................⅝''-11UNC
Weight (Tool only): ..................... 3.52 lbs (1.6 kg)
Wear ear-muff s.
The impact of noise can cause damage to
hearing.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
Anl_Axxio_18_115_Q_SPK7_USA.indb 13 Anl_Axxio_18_115_Q_SPK7_USA.indb 13
EN
Limit the operating time.
All stages of the operating cycle must be
considered (for example, times in which the
electric tools are switched off and times in which
the tool is switched on but operates without load).
5. Before starting the equipment
Warning!
Always remove the battery pack before
)
-1
making adjustments to the equipment.
⁄ '' (115 mm)
1
2
⁄ " x ⅞'' x ¼''
1
2
5.1 Fitting the additional handle (Fig. 2)
•
The angle grinder must not be used without
⁄ " x ⅞'' x ⅛''
1
the additional handle (3).
2
•
The additional handle can be secured in any
of two positions (A, B).
Tool side
Left (position A / as
shown)
Right (position B)
5.2 Replacing and adjusting the guard (Fig. 3)
Replacing:
•
Remove the quick-clamp nut (5) and the
clamping flange underneath.
•
Open the clamp lever (6) on the guard (4).
•
Turn the guard (4) through 180° in clockwise
direction so that the guard points upwards.
•
Remove the guard (4).
To mount, proceed in the reverse order.
Adjusting:
•
Adjust the guard (4) to protect your hands
so that the material being ground is directed
away from your body.
•
The position of the guard (4) can be adjusted
to any specific working conditions. Undo the
clamp lever (6) and turn the cover (4) into the
required position.
•
Ensure that the guard (4) correctly covers the
gear wheel casing.
•
Secure the clamp handle (6) again.
•
Ensure that the guard (4) is secure.
Make sure that the guard is perfectly
secure.
- 13 -
Suitable for
Right-handed users
Left-handed users
31.05.2023 08:06:54 31.05.2023 08:06:54