Publicidad
Idiomas disponibles
Idiomas disponibles
•
Pour fuel into the tank - to do this, unscrew the cap of the tank and pour
the fuel, being careful not to overflow beyond the maximum level indicator
(see the following image) in the strainer filter.
•
Replace the filler cap by tightening it all the way.
•
Connect the generator to ground - screwing the ground wire (not included
in the device) to the ground connection in the product, and its other end is
driven into the ground.
IMPORTANT: grounding the generator is extremely important, because it
protects the operator from the effects of a possible overvoltage, for this
reason it should be fixed every time the device is used.
3.3.2 Starting the generator
a)
Make sure that no load is connected to the generator. If there is, disconnect
it.
b)
Set the overcurrent switch on the control panel to the off position - "OFF"
c)
Set the fuel valve to the open position, i.e. with the lever in the "ON"
position (see the corresponding pictogram on the housing above the lever)
EN
Publicidad
