Publicidad
Idiomas disponibles
Idiomas disponibles
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Use a soft cloth for cleaning.
j)
Replace the engine oil regularly with fresh oil.
To change engine oil, it is best done when the oil is warm because it is
thinner and flows more easily. First unscrew the oil filler cap and then the
drain plug, first putting a container for used oil underneath it. After draining
the oil, close the drain plug tightly and wipe dry the area around it from the
rest of the used oil. You can refill the engine with fresh oil.
CAUTION: heated oil is hot - risk of burns!
k)
Inspect and clean the air filter regularly and replace with a new one if
necessary.
Removing the air filter: To access the air filter, undo the clips on the housing
cover and remove the filter. Rinse the sponge filter in warm water with
detergent or in extraction gasoline. Dry the sponge filter completely before
reassembly, then soak it in a little fresh engine oil. Squeeze excess oil out
of the filter before installing it in the machine.
IMPORTANT: do not operate unit without the air filter!
l)
Check the condition of the spark plug regularly - clean it if dirty, and check
the electrode gap before reassembly and adjust if necessary.
To access the spark plug, first remove the ignition cable pipe from
the spark plug. Then the spark plug can be unscrewed.
IMPORTANT: it is best to remove the spark plug when the engine is cold or
at least cooled down.
EN
Publicidad
