Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
NOZZLE MAINTENANCE
SELF-CLEANING BRUSHROLL
If any hair is wrapped around the brushroll, continue vacuuming, using Carpet/Low Pile mode
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the self-cleaning
brushroll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
If some fibers remain wrapped around the brushroll after continued use, carefully remove them.
CLEANING THE SOFT ROLLER
Slide the Soft Roller access button
forward to release the Soft Roller.
CORD MAINTENANCE
To minimize the risk of power cord damage,
DO NOT run the vacuum over the power cord.
If this occurs, immediately shut off power to
the vacuum and remove the cord from the
brushroll or nozzle.
s h a r kc l e a n . c o m
Hand wash the Soft Roller as needed.
Use only water, and allow it to air-
dry completely for at least 24 hours.
Reinsert the Soft Roller in the front of
the nozzle until it clicks into place.
1.
DO NOT pull or carry vacuum
cleaner by the cord or use cord
as a handle.
2. DO NOT unplug by pulling on the
cord. Grasp the plug, not the cord.
3. DO NOT close the door on the cord.
4. DO NOT pull the cord around
sharp corners.
5. DO NOT leave the cord near
heated surfaces.
CHECKING FOR BLOCKAGES
DUST CUP BLOCKAGES
Detach dust cup from vacuum pod.
Empty dust cup and remove debris from
lint screen in the top of the dust cup.
HOSE BLOCKAGES
Detach hose from handle by pressing
on the release button at the top of the
hose. Detach the hose from the pod,
and check openings for blockages.
WAND BLOCKAGES
Detach wand from pod and handle,
and check both ends for blockages.
HANDLE BLOCKAGES
Detach handle from wand and check
openings for blockages.
s h a r kc l e a n . c o m
Publicidad
