Tabla de contenido
Publicidad
Daily Use
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of
competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not
work
The food is too warm.
Appliance cools too
much
Unusual noises
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to the
rating plate.
Possible cause
Temperature regulation knob is
set at number "0".
Mains plug is not plugged in
or is loose
Fuse has blown or is defective
Socket is defective
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
Set the knob at other number to
switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Please look in the initial Temperature
Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Please look in the installation
location section.
Turn the temperature regulation knob
to a warmer setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
Solution
Publicidad
Tabla de contenido
