Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
Caulking around the light
7
fixture
Caulk around the 1-2- asy Connect™ (D) and
mounting surface with silicone sealant (not
included).
Operation
1
Adjusting the lamp heads
WARNING: Risk of fire. Keep the lamp heads at least
2 in. (51 mm) from combustible materials.
CAUTION: Keep lamp heads 30° below horizontal to
avoid water damage and electrical shock.
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
If needed, gently grasp the lamp heads (A)
and tilt them up or down to adjust the light
coverage area.
NOTE: The lamp heads are designed to rotate up and
down only. Do not attempt to rotate any other direction.
A
D
Rotating the sensor controls
2
downward
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
Rotate the motion sensor (C) so the controls
face toward the ground.
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
C
7
Please contact 1-866-308-3976 for further assistance.
HOMEDEPOT.COM
Publicidad
