Ryobi AC053N1FH Manual Del Usuario página 7

WARNING:
To reduce the risk of injury, user must read and understand the op-
erator's manual for their string trimmer before using this accessory.
Always wear eye protection with side shields marked to comply
with Z87.1 along with hearing protection. Ensure compatibility and
proper fit before using this accessory. Stop the string trimmer and
remove battery pack or disconnect spark plug wire before changing
or adjusting accessories.
WARNING:
Do not use this accessory if a part is damaged or missing. If you are
not comfortable performing any of the functions described in these
instructions, take your unit to an authorized service center. Use of a
trimmer head that has been improperly assembled could cause the
trimmer head to come apart and/or detach from your trimmer and
result in serious personal injury and/or property damage.
PACKING LIST
See Figures 1 - 2.
Trimmer Head Assembly, Spacer, Silver Bolt, Black Bolt, Silver Nut, Black
Nut, Black Line Guide, White Line Guide, 0.095 in. Line (16 ft.), Locking
Pin, SPEED WINDER , and Operator's Manual
™
INSTALLING TRIMMER HEAD
See Figures 1 - 6.
The Bump Feed String Head installs differently on different string trimmer
attachments. Assembly instructions will vary based on the style and type
of attachment you have. See figures 3 and 4 to determine if you have a
curved shaft or straight shaft attachment and if your attachment comes
with or without an arbor. Refer to the Installation Chart to determine the
appropriate items for your attachment. Be sure to follow the instructions
for your attachment style and type.
NOTE: If you cannot identify the style and type of attachment you have,
contact customer service for assistance.
 Stop the engine or motor, disconnect the spark plug wire for gas power
heads, remove the battery pack for cordless power heads, or disconnect
the plug from the power source for electric power heads.
 Remove the bump feed trimmer head housing by rotating the lower
housing counterclockwise so the arrow on the upper housing aligns with
the outside arrow on the bump feed housing.
NOTE: The housing is spring loaded and will self eject when unlocked.
 Separate the upper housing, spring, spool, knob, from lower housing
and set aside.
 Locate the bolt or nut, line guide, and/or spacer required to install the
trimmer head to your attachment. Refer to the Installation Chart for
details.
INSTALLATION CHART
If the trimmer head does not fit with any of the adaptors or
hardware supplied, contact Customer Service at 1-800-860-4050
for assistance.
Style Type
Curved With Spacer, Upper Housing, Spring, White Line Guide,
Shaft Arbor Spool, Black Bolt, Knob, and Lower Housing
Curved Without Upper Housing, Silver Nut, Spring, Black Line
Shaft Arbor Guide, Spool, Knob, and Lower Housing
Straight With Spacer, Upper Housing, Spring, White Line Guide,
Shaft Arbor Spool, Silver Bolt, Knob, and Lower Housing
Straight Without Upper Housing, Black Nut, Spring, Black Line
Shaft Arbor Guide, Spool, Knob, and Lower Housing
995000954
7-25-19 (REV:01)
BUMP FEED STRING HEAD
3-IN-1 READY
AC053N1BFH
Items Needed for Installation
UPPER
HOUSING
SPEED
SPOOL
WINDER
™
SPACER SILVER
BOLT
BLACK
BOLT
CURVED
SHAFT
CURVED SHAFTS
ARBOR
SPRING
KNOB
LOWER
HOUSING
LOCKING
PIN
SILVER
NUT
BLACK
WHITE
LINE GUIDE
LINE GUIDE
STRAIGHT
SHAFT
STRAIGHT SHAFTS
Fig. 1
BLACK
NUT
Fig. 2
Fig. 3
ARBOR
Fig. 4