Thermador Professional PRO-GRAND PRD30 Manual De Instalación página 12

HAZARD:
* Use extreme caution when drilling holes
into the wall or floor. There may be
concealed electrical wires located behind
the wall or under the floor.
* Identify the electrical circuits that could be
affected by the installation of the Anti-Tip
Device, then turn off power to these
circuits.
* Failure to follow these instructions may
result in electrical shock or other personal
injury.
() WARNING — ELECRICAL SHOCK
WARNING:
+ All Ranges can tip.
* — Injury to Persons could result.
* — Install Anti-Tio Device packaged
with range.
* Verify the that anti-tip device is
engaged.
* See Installation Instructions.
ATTENTION — PROPERTY DAMAGE:
* Contact a qualified installer or contractor to determine
the proper methed for drilling holes through the wall or
floor material (such as ceramic tile, hardwood, etc.)
* Do not slide the range across an unprotected floor.
* Failure to follow these instructions may result in
damage to wall or floor coverings.
Tools Needed for Installation of Anti-Tip
Device:
* Screwdriver, Phillips
« Drill, electric or hand
* Measuring tape or ruler
* 1/8" drill bit (wood or metal wall or floor)
* 3/16" carbide-tipped masonry drill bit (concrete or
concrete block wail or floor)
* 3/16" anchors, drywall or concrete, 4 each (not
required if mounting bracket is being attached to solid
wood or metal)
« Hammer
* Pencil or other marker
English 10
30 and 36 Inch Ranges
See Figure 7a and Figure 7b.
Thermador
Service Part
No.
Description
415078 4 Screw, Phillips, #10 x 1-1/2"
Anti-Tip Bracket,
647936 1 Floor-Mounted
NOTICE:
48" Ranges do not require the Anti-Tip Bracket. This is due
to the size and weight distribution of the 48" models.
Important Installation Information:
* The anti-tip bracket may be attached to a solid wood
cabinet having a minimum wall thickness of 3/4".
* The thickness of the wall or floor may require use of
longer screws, available at your local hardware store.
* In all cases, at least two (2) of the bracket mounting
screws must be fastened to solid wood or metal.
* Use appropriate anchors when fastening the mounting
bracket to any material other than hard-wocd or metal.
Figure 7a: Mounting Anti-tip Bracket