Tenda K4P-4TR Guia De Instalacion página 7

II Install the camera
Fix the camera
Tips
Please make sure the wall or the ceiling is strong enough to withstand three times the weight of the camera.
−
−
You may need to prepare a hammer drill, a drill bit, a rubber hammer, a screwdriver, and a ladder for the installation.
The camera supports wall and pendant mounting. The mounting bracket of wall mounting is included in
the package. If you want to install the camera by pendant mounting, please purchase the bracket by
yourself.
The wall mounting is taken as an example here.
Unfasten the horizontal adjustment screw on the
bottom, rotate the swing bracket to a suitable angle,
and then fasten the screw.
Horizontal adjustment screw
Install the camera (Running the cable through the wall
is taken as an example)
Thread diameter: 6 mm;
Length: 25 mm
self-tapping screw
Install the waterproof kit
You can install the waterproof kit and wrap the end with waterproof tape for the Ethernet port as required.
When you connect the Ethernet cable to the Ethernet port of the camera, the waterproof kit installation
steps are as follows.
Tips
The included waterproof kit is not suitable for the Ethernet cable with protection cover on the
crystal head. See the example on the right.
Marker pen
Swing bracket
Anchor
Adjust the monitoring direction and fix the camera
Vertically adjust
Vertical adjustment screw
Horizontally adjust
Horizontal adjustment screw
- 4 -
Thread diameter: 6 mm; Length: 6
mm machine screw