Descargar Imprimir esta página

Harbor Breeze MILROY Manual Del Usuario página 13

Ventilador de techo húmedo

Publicidad

Idiomas disponibles

Idiomas disponibles

FINAL INSTALLATION
CAUTION: Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at the fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Fasten the decorative cover (I) to the fan
4.
motor assembly (F) by use the decorative nut
(J) provied. Make sure the decorative nut are
TIGHT!
OPERATING INSTRUCTIONS
NOTE: The remote has been pre-paired in the
factory for your convenience.
NOTE: Batteries will weaken with age and should
be replaced before leaking takes place as this will
damage the remote control. Dispose used
batteries properly and keep them out of the reach
of children. Do not dispose batteries in fire.
Batteries may explode or leak. Do not mix old
and new batteries. Do not mix alkaline, standard
(carbon - zinc), or rechargeable (nickel-cadmium)
batteries. Exhausted batteries are to be removed
from the product. Non-rechargeable batteries are
not to be recharged.
1. Remove the battery cover by pressing firmly
on the arrow and sliding the cover off.
2. Install two 1.5V AAA batteries (included).
Batteries are to be inserted with the correct
polarity.
3. Slide the battery cover on the remote control
till it click in place.
4
1
Batteries
13
Battery Cover
Remote
Control

Publicidad

loading