Black and Decker ST4500 Manual De Instrucciones página 9

3. Unwrap about onefoot(30cm)[
oflinetoensure t hat i t's /
undamaged. IfitisOKrewind i t
andinsert thelineend through
theeyelet inthespool hubas
shown i nfigure19.Pull
4 in.(10cm) o ftheline through
thehole and maintain tension
while placing t hespool down
into thehubwith thearrow up,
asshown i nfigure 20.
4. Press t he spool down GENTLY
and rotate i tuntil youfeel i tdrop
into place. (When i nplace, the
spool will t urn afew degrees left
and right f reely). Take c are to
keep theline from becoming
trapped u nder thespool.
5. Snap thehub capback on,and
power thetool o n.Ina few
seconds ortess you'll hear t he
nylon l inebeing cut
automatically totheproper length.
SPOOL O R
LINE REPLACEMENT
USE ONLY .065 in. (1.65mm) DIAMETER NYLON
MONOFILAMENT LINE. Heavier line will overload the motor and
cause overheating. This line is available at your local dealer or
authorized service center.
Do not use fishing line or other lines that are not recommended.
1. Perform step 1 above to remove cap.
2. Remove the spool from the toot and remove and discard all line
on the spool.
3. Choose either OPTION 1 or OPTION 2 below for spool or line
replacement. Perform steps listed under Option 1 or Option 2,
then continue with steps 4 through 6 below.
4. Insert the line end through the eyelet in the spool hub, as shown
in figure 19. Pull the line through the hole to maintain tension
while placing the spool down into the hub, as shown in figure 20.
5. Press the spool down GENTLY and rotate it until you feel it drop
into place. (When in place, the spool will turn a few degrees left
and right freely). Take care to keep the line from becoming trapped
under the spool.
6. Snap the hub cap back on, and power the tool on. In a few
seconds or less you'll hear the nylon line being cut automatically
to the proper length.
OPTION 1: ACCESSORY REPLACEMENT SPOOL
Use Black & Decker replacement spool Model No. AF-100. Discard
old spool.
OPTION 2: REWINDING SPOOL USING BULK LINE
Bulk line for your trimmer/edger is available at extra cost from your
local dealer or Black & Decker Service Center. To install bulk line,
follow the steps below. (Use .065 in. diameter ROUND
line only)
1. Insert one end of the bulk line
into the hole in the spool as
shown in figure 21 about
1/2 in. (12 mm).
2. Hold the line in the hole and
3,
putt the rest of the line through
the slot in the spool.
Snugly and evenly wind the
bulk line onto the spool in the
direction of the arrow on the
spool until the line builds up to
the notches in the spool rim.
Do not overfill spool. The spool holds 30 feet (10 m) of line.