Publicidad
Idiomas disponibles
Idiomas disponibles
Description
The W240 & T240 Weed Wiper is designed for the selective application of herbicide to weeds / vegetation on pasture.
The W240 Weed Wiper is a trailed attachment, with applicator roller rotated around a horizontal plane in direction counter to the direction of
motion. This ensures even coverage of the waterborne herbicide to the underside of the weeds. The herbicide itself is applied to the applicator
roller via sprayer nozzles located above, fed from a tank and pump fitted to the top of the machine. The T240 Weed Wiper is a 3 point linkage
mounted attachment, following the same design & operation principles as the W240.
These machines should however only be used to perform tasks for which they were designed - use of the machine for any other function may be
both dangerous to persons, and potentially damaging to components. Use of the machine beyond the stated usage may invalidate any applicable
warranty, as well as being potential in breach of applicable safety regulations.
Weed wiping using herbicide is a controlled practice, and as such it is the operators
responsibility to ensure the correct accreditations / licenses are held for the territory
Identification
Each machine is fitted with a serial plate (shown below) which details the
following:
1.
Model
2.
Date of Manufacture (DOM)
3.
Serial Number
4.
Mass
When enquiring regarding spares or additional equipment, ensure you have
this information to hand.
Implement Decals
If your implement does not contain all of the decals shown below, please contact Chapman Machinery for replacement decals before use. Note:
All decals must be present and visible. It is imperative that these are replaced if damaged to prevent potential harm to users.
CAUTION - Read operators
manual before handling this
machine. Observe
instructions and safety rules
when operating.
the machine is being used in!
WARNING - Entanglement
Hazard. Keep hands away
from moving parts
3
English
Publicidad
