Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
we wish you a pleasant and successful working experi-
ence with your new scheppach machine.
Note:
According to the applicable product liability law the
manufacturer of this device is not liable for damages
which arise on or in connection with this device in case
of:
• improper handling,
• non-compliance with the instructions for use,
• repairs by third party, non authorized skilled work-
ers,
• installation and replacement of non-original spare
parts,
• improper use,
• failures of the electrical system due to the non-com-
pliance with the electrical specifications and the
VDE 0100, DIN 57113 / VDE 0113 regulations.
Recommendations:
Read the entire text of the operating instructions prior
to the assembly and operation of the device.
These operating instructions are intended to make it
easier for you to get familiar with your device and uti-
lize its intended possibilities of use.
The operating instructions contain important notes on
how to work safely, properly and economically with
your machine and how to avoid dangers, save repair
costs, reduce downtime, and increase the reliability
and working life of the machine.
In addition to the safety regulations contained herein,
you must in any case comply with the applicable regu-
lations of your country with respect to the operation of
the machine.
Put the operating instructions in a clear plastic folder
to protect them from dirt and humidity, and store them
near the machine. The instructions must be read and
carefully observed by each operator prior to starting
the work. Only persons who have been trained in the
use of the machine and have been informed on the
related dangers and risks are allowed to use the ma-
chine. The required minimum age must be met.
18 | GB
In addition to the safety notes contained in the present
operating instructions and the special regulations of
your country, the generally recognized technical rules
for the operation of wood working machines must be
observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Equipment Fig. 1
1.
ON/OFF switch
2.
Housing
3.
Grey cast iron table
4.
Tool spindle
5.
Table inlets
6.
Rubber sleeves
7.
Abrasive sleeves
8.
Table inlay slot
9.
Rubber and abrasive sleeves slot
10. Vacuum connector
11. Lower spindle disc
12. Upper spindle discs (3 pcs.)
a. small 16 mm
b. medium 20 mm
c. large 35 mm
13. Hook wrench SW 13
3. Delivery Status
• oscillating spindle grinding machine
• workbench of massive grey cast iron
• 6 abrasive sleeves (K80, ø 15/21/28/40/53/77 mm)
• 5 rubberized grinding rolls (115 mm)
• 6 table inlays ø 18/25/31/44/57/82 mm
• 4 spindle discs ø 14/22/46/71
• mounting tool
• Operation Manual
General Notes
• When you unpack the device, check all parts for
possible transport damages. In case of complaints
the supplier is to be informed immediately. Com-
plaints received at a later date will not be acknowl-
edged.
• Check the delivery for completeness.
• Read the operating instructions to make yourself
familiar with the device prior to using it.
• Only use original parts for accessories as well as for
wearing and spare parts. Spare parts are available
from your specialized dealer.
www.scheppach.com
Publicidad
