Indesit VRH 600 X Manual De Instrucciones página 3

Fixing
The appliance must be installed
supporting surface.
Any deformities caused by improper fixing could affect
the features and operation of the hob.
The thickness of the supporting surface
into account when choosing
the fixing hooks:
• 30 mm thick: 17.5 mm screws
• 40 mm thick: 7.5 mm screws
Fix the hob as follows:
1. Use short flat-bottomed screws to fix the 4 alignment
springs in the holes provided at the central point of
each side of the hob.
2. Place the hob in the cavity, make sure it is in a
central position and push down on the whole perimeter
until the hob is stuck to the supporting surface.
3. For hobs with raised sides: After inserting the hob
into its cavity, insert the 4 fixing hooks (each has its
own pin) into the lower edges of the hob, using the
long pointed screws to fix them in place, until the glass
is stuck to the supporting surface.
! The screws for the alignment springs must remain
accessible.
In order to adhere to safety standards, the appliance
!
must not come into contact with electrical parts once it
has been installed.
All parts which ensure the safe operation of the
!
appliance must not be removable without the aid of a
tool.
Connecting the hob to the oven
This appliance can only work if it has been connected
to a specific oven, listed on the sheet included in the
documents pouch.
VRH 600 C - VRH 600 X - VRH 640 C - VRH 640 X -
VRH 60 C - VRH 60 X
on a perfectly level
should be taken
the length of the screws for
PIANO INCASSO
BIANCO ROSSO GIALLO BLU
CUCINA INCASSO
VRH 641 D C - VRH 642 DO X
BUILT-IN CERAMIC HOBS
BLUE WHITE RED
OVEN
GB
VERDE
YELLOW GREEN
3