DeWalt DCL040 Manual De Instrucciones página 35

To install the battery pack (D) into the tool handle, align the battery
pack with the rails inside the tool's handle and slide it into the handle
until the battery pack is firmly seated in the tool and ensure that it
does not disengage.
To remove the battery pack from the tool, press the release button (E)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
Either battery (DCB200 or DCB201) may be used. Consult the chart
at the end of this manual for compatibility of chargers and battery
packs.
Switch (Fig. 2)
To turn the light on, press the switch (A). To turn it off, press the switch
again.
FIG. 4
FIG. 5
B
33
Pivoting Head (Fig. 2, 4)
The pivoting head rotates to provide light in the range of -10° to 100°.
Carrying and Suspending the Light
(Fig. 2, 5)
CAUTION: When light hangs by the loop, do not shake the light
or the object from which it hangs. Do not hang the light from any
electrical wires or anything that is not secure. Personal injury or
property damage may occur.
CAUTION: Only use the loop for hanging the LED worklight. The
loop is not intended to support additional weight. Do not attach or
hang anything additional to the light or risk of breakage may occur.
CAUTION: Do not use the loop to reach with or to support your
weight in any situation.
LOOP (FIG. 2, 5)
The light may be carried or hung by the loop (B). When not in use, the
loop may be folded down.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury,
turn light off and disconnect battery pack before making
any adjustments or removing/installing attachments or
accessories.
• Do not attempt to repair the worklight. To assure product safety
and reliability, repairs, maintenance, and adjustments should be
performed by authorized D WALT service centers.
E
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air
as often as dirt is seen collecting in and around the air vents. Wear
approved eye protection and approved dust mask when performing
this procedure.