Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTi
G
to
See appropriate
section in manual unless directed
PROBLEM
CAUSE
Does not start
1.
J Loss of power
Engine idles or
runs roughly
Excessive
vibration
RecoiJ starter
jis hard to pull
Loss of traction
drive / slowing
iof drive speed
Loss of snow
discharge
or
jslowing of
J snow discharge
Fuel shut-off valve (if so
equipped) in OFF position.
2.
Safety ignition key
is not inserted.
3.
Out of fuel.
4.
Throttle in STOP position.
5.
Choke in OFF position.
6.
Primer not depressed.
7.
Engine is flooded.
8.
Spark plug wire is
disconnected.
9.
Bad spark plug.
10. Stale fuel.
11. Water in fuel.
1.
Spark plug wire loose.
2.
Throwing too much snow.
3.
Fuel tank cap is covered
with ice or snow.
4.
Dirty or clogged muffler.
1.
Choke is in FULL position.
2.
Blockage in fuel line.
3.
Stale fuel.
4.
Water in fuel.
5.
Carburetor is in need of
adjustment or overhaul.
.
Loose parts or damaged
augers or impeller.
1.
Frozen recoil starter.
1.
Drive belt is worn.
2.
Drive belt is off of pulley.
3.
Friction drive wheel is worn.
1.
Auger belt is off of pulley.
2.
Auger belt is worn.
3.
Clogged discharge chute.
4.
Augers / impeller jammed.
.
a Sears Parts & Repair Center.
CORRECTION
Turn fuel shut-off valve to OPEN position.
2.
Insert safety ignition key.
3.
Fill fuel tank with fresh, clean gasoline.
4.
Move throttle to FAST position.
5.
Move to FULL position.
6.
Prime as instructed in the Operation section of this manual.
7.
Wait a few minutes before restarting, DO NOT prime.
8.
Connect wire to spark plug.
9.
Replace spark plug.
10. Empty fuel tank & carburetor, refill with fresh, clean gasoline.
11. Empty fuel tank & carburetor, refill with fresh, clean gasoline.
1.
Reconnect spark plug wire.
2.
Reduce speed and width of swath.
3.
Remove ice and snow on and around fuel tank cap.
4.
Clean or replace muffler.
1.
Move choke to OFF position.
2.
Clean fuel line.
3.
Empty fuel tank & carburetor, refill with fresh, clean gasoline.
4.
Empty fuel tank & carburetor, refill with fresh, clean gasoline.
5.
Contact a Sears Parts & Repair Center.
1.
Tighten all fasteners.
Replace damaged parts. If vibration
remains, contact a Sears Parts & Repair Center.
1.
See "IF RECOIL STARTER HAS FROZEN"
in the Operation section of this manual.
1.
Check/replace
drive belt.
2.
Check / reinstall drive belt.
3.
Contact a Sears Parts & Repair Center.
1.
Check / reinstall auger belt.
2.
Check / replace auger belt.
3.
Clean snow chute.
4.
Remove debris or foreign object from augers / impeller.
20
Publicidad
