Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATIO
TO THROW SNOW (See Fig. 15)
The auger rotation is controlled by the auger control lever
located on the right side handle.
•
Squeeze auger control lever to handle to engage the
auger and throw snow.
•
Release the auger control lever to stop throwing snow.
AUGER
CONTROL
LEVER
FIG. 15
USING THE CLEAN-OUT
TOOL (See Fig. 16)
In certain snow conditions, the discharge chute may be-
come clogged with ice and snow. Use the clean-out tool
to dislodge this blockage.
When cleaning,
repairing,
or inspecting, make
certain all controls
are disengaged
and the au-
ger/impeller
and all moving parts have stopped.
Disconnect
the spark plug wire and keep the
wire away from the spark plug to prevent
ac-
cidental
starting.
TO MOVE FORWARD AND BACKWARD
(See Fig. 17)
SELF-PROPELLING,
forward and reverse movement of
the snow thrower, is controlled by the traction drive control
lever located on the left side handle.
•
Squeeze traction drive control lever to handleto engage
the drive system.
•
Release traction drive control lever to stop the forward
or reverse movement of the snow thrower.
SPEED and DIRECTION are controlled by the drive speed
control lever.
Press downward on the speed control lever and move
lever to desired position BEFORE engaging the trac-
tion drive control lever. Be sure lever springs back and
locks into desired position.
CAUTION:
Do not move speed control lever
when traction
drive control
lever is engaged.
Damage to the snow thrower
can result.
•
Slower speeds are for heavier snow and faster speeds
are for light snow and transporting the snow thrower. It
is recommended that you use a slower speed until you
are familiar with the operation of the snow thrower.
NOTE: When both traction drive and auger control levers
are engaged, the traction drive control lever will lock the
auger control lever in the engaged position. This will allow
you to release your right hand from the handle and adjust
the discharge chute direction without interrupting the snow
throwing 3rocess.
e
e
Release the auger control lever and shut offthe engine.
Removethe clean-out tool from it's mounting clip. Grasp
the tool firmly by the handle and push and twist the tool
into the discharge chute to dislodge the blockage.
After the packed snow has been dislodged, return the clean-
out tool to it's mounting clip by pushing it into the clip.
•
Make sure the discharge chute is pointed in a safe di-
rection (no vehicles, buildings, people, or other objects
are in the direction of discharge) before restarting the
engine.
•
Restart the engine, then squeeze the auger control
lever to the handle to clear snow from the auger hous-
ing and the discharge chute.
DISCHARGECHUTE
\
CLEAN-OUT<,_
TOOL
MOUNTING
TRACTION
DRIVE
_LLEVER
/
/
i
DRIVE S
CONTROL
LEVER
FIG. 17
POWER STEERING OPERATION (See Fig. 18)
Steering triggers are used to assist in steering your snow
thrower, The triggers are located on the underside of each
handle. When atrigger is squeezed, it disengages the drive
wheel on that side of snow thrower and allows it to turn in
that direction.
•
To turn left - squeeze left side trigger,
•
To turn right - squeeze right side trigger.
LH TURN
RH TURN
TRIGGER
TRIGGER
FIG. 16
12
FIG. 18
Publicidad
