Publicidad
Idiomas disponibles
Idiomas disponibles
C[eanShot
TM
2050
PSI Pressure
Washer
O-Rin
Maintenance
Purchase an O-Ring/Haintenance
Kit, part number
191922GS by contacting the nearest authorized
service
center. It is not included with the pressure washer.This kit
inchdes
rephcement
o-rings_ rubber washer and water
inlet filter. Refer to the instruction
sheet provided in the kit
to service your unit's o-rings.
Pump
Maintenance
Changing
Pump
OH
Change oil every S0 hours or once yearly, whichever
occurs first.
NOTE:
Purchase a premeasured
bottle of pump oil item
number
190586GS_ by contacting
the nearest authorized
service center.
Change
pump
oil as follows:
I.
Drain engine oil and fuel from pressure washer.
2.
Use a 8ram allen wrench to remove bhck pump oil cap
between high pressure outlet and garden hose inlet
(Figure 16).
Oil Cap
3.
Tilt pressure washer to drain oil into an approved
container until it drips slowly from pump.
4.
Tilt pressure washer in opposite
direction
and empty
premeasured pump oil bottle into same opening (a
small funnel may be helpful).
5.
Install bhck pump oil cap and tighten firmly.
6.
Set pressure washer in upright position.Add
fuel and
engine oil.
ENGINE
HA[NTENANCE
See the engine owner's manual for instructions
on how to
properly maintain the engine.
CAUTION
Used motor oil has been shown to cause skin cancer in
certain laboratory animals,
Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN.
DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OILTO
COLLECTION
CENTERS.
U4
Publicidad
