Publicidad
Idiomas disponibles
Idiomas disponibles
CleanShot
TM
2050
PSI Pressure
Washer
ASSEMBLY
mNPORTANT:
Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
Remove
Pressure Washer
From
Carton
1.
Remove the parts bag, accessories_ and inserts inchded
with pressure washer,
2.
Ske two corners at the end of carton from top to
bottom
so the panel can be folded down fiat.
3.
Remove pressure washer from carton.
Carton
Contents
ffems
in the carton
include:
Hain Unit
Handle
High Pressure Hose
Spray Gun
Adjustable
Nozzle Extension
Safety Goggles
Oil Bottle
Parts Bag (which includes the following):
Owner's
Manual
Engine Manual
Owner's
Registration Card
Handle Fastening Hardware
Kit (which includes):
Carriage Bolts (2)
"U' Hooks (2)
Plastic Knobs (4)
PREPARING
PRESSURE
WASHER
FOR
USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-743-4115.
If calling for
assistance, please have the model, revision, and serial
number from the data tag available.
To prepare
your
pressure
washer
for operation,
you
wii[ need to perform
these
tasks:
I.
Fill out and send in registration
card.
2.
Attach handle to main unit.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect high pressure hose to spray gun and pump.
6.
Connect water supply to pump.
7.
Attach nozzle extension
to spray gun.
Attach
Handle
I.
Place handle assembly onto handle supports connected
to main unit. Hake sure holes in handle align with
holes on handle supports (Figure I).
Align H oles ___i_l__
_
_
Hande
l/
Supports /
NOTE:
It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2.
Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit
(Figure 2).Tighten
by hand.
3.
Insert one "U' hook through hole just above billboard
on left side of handle (viewing from rear of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 3).Tighten
by hand.
Hose Hook
Spray Gun Hook
Insert other "U' hook through hole just above
billboard on right side of handle (viewing from rear of
unit). Hold hook in place and attach a plastic knob
from inside of unit (Figure 3).Tighten
by hand.
6
Publicidad
