Publicidad
Idiomas disponibles
Idiomas disponibles
C,eanShot PS, Pressure
Washer
CleanShot
Add
Engine
Oil and Fuel
* Place pressure
washer
on a level surface.
i
• Refer to engine manuaI for oil and fuel fill information.
• Damage to equipment
resulting from failure to foJJow this
instruction
will void warrant)i.
• Refer
to engine
owner's
manual
and follow
oil and fuel
recommendations
and instructions.
NOTE:
Check
oil often
during
engine
break-in.
Refer
to
engine
owner's
manual
for recommendations.
Connect
Hose and Water
Supply
to
mHPORTANT:
To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
NOTE:
Remove and discard the shipping caps from the
pumps high pressure outlet
and water inlet before
attaching hoses.
I.
Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure 4).Tighten
by hand.
hose here
2.
Attach other end of high pressure hose to high
pressure outlet on pump (Figure S).Tighten by hand.
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 6). Clean screen if it contains
debris or have it replaced if damaged. DO NOT RUN
PRESSURE WASHER IF INLET SCREEN IS DAMAGED.
_\
Inspect
inlet
.... \\
screen, DO
NOT
use if damaged;
clean if dirty.
4.
Run water through your garden hose for 30 seconds
to clean out any debris.
mNPORTANT:
DO NOT siphon standing water for the
water supply. Use ONLY cold water
(less than 100°F).
S.
Connect the garden hose (not to exceed S0 feet in
length) to the water
inlet.Tighten
by hand (Figure 6).
Damage
to equipment
resulting
from
failure to follow
this
instruction
wiJl void warranty,
6.
Turn
ON
the water
and squeeze
the trigger
on the
gun to purge
the pump
system
of air and impurities.
WARNING
Always wear eye protection
when
using this equipment
or in
vicinity
of where
equipment
is in use.
Before starting the pressure washer, be sure you are wearing
adequate
eye protection,
Checklist
Before
Startin ine
Review
the unit's assembly
to ensure
you have performed
all of the following.
I.
Make sure handle
is in place and secure.
2.
Check
that oil has been added
to proper
level in the
engine
crankcase.
3.
Add
proper
gasoline
to fuel tank.
4.
Check
for
properly
tightened
hose connections.
S.
Check
to make sure there
are no kinks, cuts, or
damage
to
high
pressure
hose.
6.
Provide
a proper
water
supply
at an adequate
flow.
7.
Be sure to read "Safety
Rules"
and "HowTo
UseYour
PressureVVasher"
before
using pressure
washer.
7
Publicidad
