Publicidad
Idiomas disponibles
Idiomas disponibles
Four different size allen wrenches are provided to assist
BASE
ASSEMBLY
in the assemMy of the Mortiser,
1,
DO NOT assembb
the Mortiser until you are sure
the tooUis disconnected from the power source,
2,
DO NOT assembb
the Mortiser until you are sure
the power switch is in the off position,
HYDRAULIC
CYLINDER
ASSEMBLY
Make sure that the machine is disconnected from the
power source,
Figure
4
\
A
B
i
/
/
/
Make sure that the machine is disconnected from the
powe r sou rce,
Figure
6
C
0
1,
Thread Lower Ball Stud Fitting (A) into hob (B) of
the column of the mortiser as shown in Figure 4,
Figure
5
C
1,
2,
3,
4,
Place Mortiser column (A) over the base (B) align-
ing the four hobs in the mortiser column with the
four hobs in the base, See Figure 6,
Place one M8 lock washer and one M8 fiat washer
on each of the four M8 x 30mm hex head screws,
insert three of M8 x 30mm hex head screws
through the bottom of the mortiser, thread into the
base and tighten securely, See Figure 6,
Loosen set screw (C) and position depth stop rod
(D) so that it comes in contact with the base as
shown in Figure 6,
5,
Tighten set screw,
2,
Snap the Hydraulic Cylinder (C) over the Upper Ball
Stud Fitting (D) on the back of the mortiser head by
applying firm pressure to the cylinder, See Figure 5,
3,
Attach the other end of the hydraulic cylinder to the
lower ball stud fitting installed in Step 1,
10
Publicidad
