Craftsman 152.219070 Manual De Instrucciones página 19

ATTACHUNG COLUMN EXTENSUON
The coUumn can be extended for the purpose of mortis-
ing taller workpbces
Make certain the machine is disconnected from the
power source,
Figure 28
5, Snap off the hydraulic cylinder (G) and remove the
lower ball stud fitting (H), See Figure 29,
6, Remove the 4 M8 x 30ram Hex Head screws (I)
and remove the mortiser column (J) from the
base (K),
7, Remove the 4 M8 Lock Washers and 4 M8 Fiat
Washers from the 4 M8 x 30ram Hex Head screws
and put them on the 4 M8 x 80mm Hex Head
Screws,
C
1, Remove the 2 M4 x 8mm Pan Head Screws (A)
that fasten the MicroAdjust Assembly (B),
See Figure 28,
2, Loosen Lock Knob (C) and remove micro adjust
assembly from the Fence Glide Shaft (D),
3, Remove Short Fence Lock Handle (E),
4, Slide Fence Glide Shaft completely out of the
mortiser column (F),
Figure 29
Figure 30
8,
9,
10,
11,
12,
Line up the hobs in the spacer block (L) with the
hobs in the base, See Figure 30,
Place mortiser column over the spacer block and
fasten to base using the 4 M8 x 80mm Hex Head
Screws, 4 M8 Lock Washers and 4 M8 Fiat
Washers,
Slide Fence Glide Assembly into the hob in the
Spacer Block,
Thread Long Fence Lock Handle (M) into spacer
block,
Place Micro Adjust Assembly over the Fence Glide
Shaft and fasten to the mortiser column using the
2 M4 x 8ram Pan Head Screws and 2 M4 Fiat
Washers,
19