Publicidad
Idiomas disponibles
Idiomas disponibles
Figure
7
Figure
9
G
\
6,
Detach Hydraufic Cyfinder (E) from bwer bah stud
fitting See Figure 7,
7,
Unscrew bwer bail stud fitting (F),
8,
insert finaU M8 x 30mm hex head screw (G) through
the bottom of the mortiser, thread into the base,
and tighten secureUy,
9,
Screw in bwer bail stud fitting and reattach the
hydraulic cylinder as expUained in HYDRAUMC
CYMNDER ASSEMBLY,
FENCE ASSEMBLY
Make sure that the machine is disconnected from the
power source
Figure
8
C
\
E
F
1,
insert Guide Rod (A) through hob in HoUdDown (B)
and tighten set screw (C) using supplied 4mm T
Handb aflen wrench,
See Figure 8,
2,
insert Guide Rod into hob (D) of Fence AssemMy
(E) and tighten set screw (F) using supplied 4mm
T Handle allen wrench,
G
3,
Insert fence glide shaft (G) through hole (H) in
column of the mortiser, See Figure 9,
Figure
10
\
11
4.
Thread Short Fence Lock Handle (I) into the
column of the mortiser. Tighten to secure fence.
See Figure 10.
NOTE: Fence Lock Handle is spring loaded and can be
repositioned by puffing out on the handle and rotating it,
Publicidad
