Diamond ADD-27/MX Manual De Instrucciones página 4

General instructions
1. The relevant installation and operation instructions contained in this manual must be read prior to
the installation and operation of this device.
2. The manufacturer will not bear responsibility in case of improper use and incorrect operation of
the device.
3. The system is used only for removing unwanted mineral substances, which accumulate as lime
scale (Calcium and Magnesium). This device is a part of the system protection.
4. It is forbidden to make change in the system without consultation with the manufacturer. The
manufacturer will not bear responsibility in case of any damage caused by this type of
modification.
5. The temperature in the device operating room must be at least 10 ̊ C
6. The general regulations and provisions as well as provisions concerning accident prevention
must be observed at the installation location of the device.
7. The installation location of the device must be secured from any damage caused by water (e.g. by
the existing floor drain). The manufacturer is not responsible for any damage caused by water.
8. The appliance in which the filter is used must be free of limescale and gypsum deposits prior to
installation.
9. Do not assemble near sources of heat and open flames.
10. Protect the filter system from mechanical damage.
11. Installation and maintenance of the filter system may only be carried out by trained and authorized
personnel.
12. For cleaning do not use any abrasive chemicals, cleaning solutions or astringent cleaning agents
13. The proper name and serial number of the device must be provided with any enquiries and
ordering of spare parts. Only then an effective and quick reply or order implementation is ensured.
Transportation and packaging
Prior to shipment our systems are carefully packed and controlled.
Damage during transportation cannot be excluded in case of shipment by a shipping company.
It is necessary therefore to check the package at receipt of the product.
1. Check the completeness of the delivery based on the delivery receipt.
2. In case of damaged packaging: perform a visual inspection of the goods and record conclusions in
the shipping documentation provided by the shipping company. Make photographic
documentation of the damaged package and the device. In the shipping documentation place an
annotation of possible claiming of hidden damages, which may be revealed after start-up.
Immediately contact the shipping company because otherwise the shipping insurance will not be
available. Save the package for the purpose of any later inspections by the shipping or insurance
company.
3. In case of returning the package, it must be packed in a way to be protected against any
mechanical damage.
4. Drain water from the system prior to the shipment. This will help reduce shipping costs. It will
also prevent the packaging from damage due to potential water leakage.
After storage and transport below 0 °C, the product must be stored in the open original packaging for
at least 24 hours before it is commissioned at the stated ambient temperatures for operation.
Liability Exclusion
Installation must be performed precisely in accordance with the instructions in this manual.
Manufacturer shall not be held liable for any damage, including subsequent damage, arising from the
incorrect installation or use of the product.
3