Diamond ADD-27/MX Manual De Instrucciones página 7

1.3. Control function
Steering Valve
Before starting, you should program the time and water hardness.
The controller is factory programmed for regeneration at 2.00 at night, for 20 oGH.
Depending on water hardness program the value in valve.
2. Preparation for installation
2.1. Installation preparation plan
Picture 1.
2.2. Dismantling and utilization
The device is dismantled after it lifetime has expired (for final destruction or scrap).
The reversed assembly steps are to be commenced.
Note!
First clean the system thoroughly with fresh water and drain the tanks and pipes completely!
Comply with workplace safety instructions in this respect!
Different parts of the device must be utilized in accordance with binding regulations of
utilization and waste management!
On the purchaser's
side:
1. Utility water
supply pipe (cold)
3/4" with a cut off
valve.
2. Drainage (sewer)
at a max. height of
100 mm,
connection DN
50.
3. Electric socket
230 V / 50 Hz, 16
A
4. Floor drainage
must be in the
room.
5. Sediment filter
should be use
before water
softener
6