Diamond ADD-27/MX Manual De Instrucciones página 5

How it works
Hard water contains the combination of calcium (Ca), magnesium (Mg). The softening process serves the
removal of the positively charged ions by means of ion-exchanged resin. When the ion-exchanged resin loses its
effectiveness it is regenerated by the reagent.
Regeneration:
The regeneration is based on rinsing the deposits using the tablet salt solution and rinsing out the absorbed
calcium and magnesium ions into the sewage.
Regeneration takes place automatically in a Intelligent mode. User just program tested water hardness (GH) and
system will calculate its efficiency. Regeneration can be also forced in time if capacity will not be reached and
day of override regeneration came system will perform regeneration. During regeneration, hard water is
available.
Regeneration process consist of 4 cycles:
1. Backwashing
2. Brine and Slow Rinses
3. Fast Rinsing
4. Refilling
Standards, provisions and statutory regulations
1. Water supplying the device must comply with the requirements of the utility water use regulation.
2. Parts that are in contact with treated water must be made of material resistant to treated water,
3. In the room for the water treatment floor drainage must be installed. The purchaser is responsible to
ensure the drainage.
4. Maximum temperature of the supply water is 40 ° C
1. Description of the device
1.1. System structure
The system of water purification type ADD-27/MX is a device of high quality and precision.
Properly installed and maintained guarantees infallible functioning for many years. The water softener station
of small efficiency type ADD-27/MX is used where the water flow does not exceed 40l/min.
System structure:
1. Water softener Type : ADD-27/MX
2. Drain hose ½"
1.2. Technical description
Quantity of softened water for 20
Resin Capacity
Electric Connection
Salt Consumption
Flow Rate
Operating pressure
Connections
Height
Depth
Width
Maximum water temperature
Salt storage capacity
o
F /regeneration [liters ] 5450
[liters] 20
[ V / Hz ] 230 / 50-60
[kg] 3,0
[l/min] 1,8-40
[bar] 2,0 - 6,0
[cal] ¾"
[mm] 1140
[mm] 540
[mm] 320
0
[ C] 40
[kg] 75
4