Publicidad
Idiomas disponibles
Idiomas disponibles
Description
The MF350 Mounted Feeder is designed for mounting into the bed of a UTV or pickup, for feeding livestock, through deposition of pre-defined
drops of feed, onto clear ground. It is recommended to use this attachment with free-flowing feed, eg. Rolls or nuts, to prevent bridging in the
hopper.
The MF350 operates with an electric motor mechanism, ensuring accurate deposition. Electronics are suitably protected against moisture & dirt
ingress to ensure trouble-free usage in even the toughest winter conditions. The MF350 has approximately 300kg carrying capacity (feed material
dependant), a galvanised metal hopper and PVC cover. Please ensure the carrying vehicle has sufficient capacity for the base machine weight
(circa 90kg) and the weight of feed in the hopper when full.
These machines should however only be used to perform tasks for which they were designed - use of the machine for any other function may be
both dangerous to persons, and potentially damaging to components. Use of the machine beyond the stated usage may invalidate any applicable
warranty, as well as being potential in breach of applicable safety regulations.
Identification
Each machine is fitted with a serial plate (shown below) which details the
following:
1.
Model
2.
Date of Manufacture (DOM)
3.
Serial Number
4.
Mass
When enquiring regarding spares or additional equipment, ensure you have
this information to hand.
Implement Decals
If your implement does not contain all of the safety decals shown below, please contact Chapman Machinery for replacement decals before use.
Note: All decals must be present and visible. It is imperative that these are replaced if damaged to prevent potential harm to users.
CAUTION - Read operators
manual before handling this
machine. Observe instructions
and safety rules when
operating.
Attachment
Before attachment, ALWAYS ensure the following:
•
The carrying vehicle has sufficient capacity for the fully laden unit (Machine weight circa 90kg + Max feed capacity (varies with feed
used, this must be checked!) = total laden weight
•
All safety guards & decals are in good working order and correctly fitted
•
Electrical connections are free of dirt and moisture
Attaching the Machine
NOTE: This machine is designed to attach to the carrying vehicle using 4 x ratchet straps. Never use less than 4 straps to secure the load as
movement may result!
WARNING - Entanglement
Hazard. Keep hands away
from moving parts
Page 3
English
Publicidad
