Epson TM-S1000 Manual Del Usuario página 11

Connecting the Scanner to the Host Computer
Follow these steps to connect the scanner to a host computer.
1. Confirm that the power is not supplied to the scanner.
2. Start the TM-S1000 Utility included on the Utility & Documents CD.
CAUTION:
Starting the TM-S1000 Utility causes the USB driver to be installed. Be sure
to start the TM-S1000 Utility before connecting the scanner to a host
computer.
Note:
If the scanner is connected to a host computer before installing the USB
driver, the Found New Hardware Wizard will be displayed. In that case,
cancel the wizard and start the TM-S1000 Utility to install the USB driver.
3. When the TM-S1000 Utility has started, connect the scanner to the
host computer via the USB cable.
CAUTION:
Hook the USB cable on the USB cable securing hook to prevent the
cable from falling off. Be sure to use the USB cable that is included with
the scanner.
USB cable
Note:
With the TM-S1000 Utility, you can check the operation of the scanner. For
more information, see the TM-S1000 Utility User's Manual.
USB connector
USB cable securing hook
CaptureOne User's Manual 9
English