Kenmore 100.84008 Guía De Uso Y Cuidado página 7

4.Attach controt assembly tothe base b y aligning the two tabs oncontrol assembly
with outer
two slots on fryer base (see Fig. 4), SIide control assembly down
as far as it wii! go, making sure that both tabs are in the slots, and heating
element is in bottom of pan. NOTE: The fryer will only operate when both tabs
are fully in place in the slots.
FIG,4 Tabs
!!?iiii
5,
6.
FitI pan with cooking oil.The amount of oil used must be between the minimum
and maximum teveis on the inside of pan, The fryer takes approximately 4 quarts
of oil, NEVER exceed the maximum IeveI of oil.
Attach the cord to the unit by
aligning the magnetic plug end
with the 3 electrical pins on the
back of the control unit. The
ptug has a ledge on it which
must be facing down. Angle
the plug so the ledge is in first,
then push in rest of plug,
FIG. 5
IMPORTANT:
The magnetic cord was designed to detach easily from
the fryer. As a result, if it is bumped or touched during use it could possibly
detach, causing the unit to stop heating. Avoid contact with cord during
operation. If contact occurs, verify that 1he cord is still properly connected.
Unit will need to be reprogrammed,