EINHELL TE-VE 550/2 A Manual De Instrucciones Original página 18

•
Wheel cap (2x)
•
Chassis
•
Strengthening plate
•
Wheel (2x)
•
Extraction hose
•
Side plate (2x)
•
Plastic housing
•
Reduction adapter
•
5-piece adapter set
•
Connection adapter
•
Axle screw (2x)
•
Washer (2x)
•
Long lock bolt (4x)
•
Short lock bolt (4x)
•
Nut (8x)
•
Original Operating Instructions
•
Safety information
3. Proper use
The vacuum extraction system is designed for ex-
tracting chippings and dust arising from the pro-
cessing of wood or wood-type materials. Never
use this equipment in an environment where there
is a risk of fi re and explosion.
The equipment is to be used only for its
prescribed purpose. Any other use is deemed
to be a case of misuse. The user / operator and
not the manufacturer will be liable for any damage
or injuries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
To use the machine properly you must also obser-
ve the safety regulations, the assembly instruc-
tions and the operating instructions to be found in
this manual.
All persons who use and service the machine
have to be acquainted with this manual and must
be informed about the machine's potential ha-
zards.
It is also imperative to observe the accident pre-
vention regulations in force in your area.
The same applies for the general rules of occupa-
tional health and safety.
GB
The manufacturer shall not be liable for any chan-
ges made to the machine nor for any damage
resulting from such changes.
Even when the machine is used as prescribed it
is still impossible to eliminate certain residual risk
factors.
The following hazards may arise in connection
with the machine's design and construction:
•
•
•
•
•
•
4. Technical data
Motor ..................................... 220-240 V ~ 50 Hz
Motor speed n
Power P ..................................................... 550 W
Max. power consumption of the
automatic socket-outlet: .......................... 2400 W
Max. total power consumption: ................ 2950 W
Max. vacuum .......................................... 1600 Pa
Max. extraction volumes ...................... 1150 m
Extractor socket ..................................... 100 mm
Sawdust bag volumes ....................................65 l
Weight ................................................... ca. 18 kg
- 18 -
www.sidirika-nikolaidi.gr
Hazard due to machine defects:
If one or more parts of the machine are de-
fective, the use of the machine is prohibited.
Defective parts must be replaced immediate-
ly. Only replacement parts which have been
approved by the manufacturer may be used.
It is prohibited to make any changes to the
machine.
Hazard due to electric shock:
Only operate the machine at a power source
which is protected by a residual-current circuit
breaker with a residual current of 30 mA!
Socket-outlets must be properly installed,
earthed and tested!
Hazard due to unintentional start-up of the
machine: The power plug must be removed
from the socket-outlet before emptying the
sawdust bag and also when the machine is
not in use!
Hazard due to wood dust: The inhalation of
wood dust is a health hazard! Always wear a
protective dust mask when emptying the de-
bris bag. When disposing of sawdust waste,
make sure you do so in an environmentally-
friendly fashion!
Fire hazard: Never use the machine to extract
hot objects!
Damage to hearing if ear-muffs are not used
as necessary.
..................................... 2850 rpm
0
/h
3