Front Panel; Rear Panel - Monacor JTS US-903DCPRO/5 Manual De Instrucciones

Diversity UHF Dual Receiver
These instructions are intended for users without
any specific technical knowledge Please read these
instructions carefully prior to operation and keep
them for later reference All operating elements
and connections described can be found on the
fold-out page 3
1 Overview

1.1 Front panel

1 Control and display panel for receiver unit CH 1
2 Control and display panel for receiver unit CH 2
3 Reception antennas
4 Indications of the charging status, each for the
left and the right pairs of rechargeable batteries
in the battery compartment
does not light up: no batteries are inserted,
the batteries are not correctly inserted or are
defective
flashes: the pair of batteries is being charged
lights up continuously: the pair of batteries is
fully charged
5 Compartment for the rechargeable batteries to
charge the supplied rechargeable nickel metal
hydride batteries (NiMH) which can be used
to supply the pocket transmitters and wireless
microphones with power
6 Volume control VOL*
7 Button * to scan the group / channel in
ascending order (in the group adjusting
mode / channel adjusting mode) and to acti-
vate the locking function (in the lock adjusting
mode)
8 Button * to scan the group / channel in
descending order (in the group adjusting
mode / channel adjusting mode) and to deacti-
vate the locking function (in the lock adjusting
mode)
9 Button SET*
with the unit not locked:
to call up and to exit the adjusting modes for
group / channel, locking function
☞ chapters 6 1, 6 1 1
with the unit locked:
to call up and to exit the adjusting mode for
the locking function
* each for the receiver unit CH 1 and the receiver unit CH 2
10
☞
chapter 6 1 1
10 Multifunction LC display (fig 2)
a indication RF* (radio frequency) for the
power of the radio signal received: the
longer the bar graph, the better the recep-
tion
b indication AF* (audio frequency) for the
volume of the audio signal received [inde-
pendent of the volume controls VOL (6)]:
the longer the bar graph, the higher the
volume level
c indication* of the group ( , , or ) and of
the transmission channel (1 – 16) The corre-
sponding frequencies are indicated in the
table fig 4 on page 13
d reception indications*
which of the two antennas receives the more
powerful radio signal
e indication MUTE*: indicates that the cor-
responding receiver unit is muted because
it does not receive any radio signal or be-
cause the radio signal received is too poor or
because the mute function of the wire-
less microphone MH-8800G / 5 has been
switched on
11 POWER switch
12 Mounting brackets to insert the receiver into
a rack ☞ chapter 4

1.2 Rear panel

13 BNC antenna jacks ANT 1 and ANT 2 for the
two supplied antennas (3)
14 Outputs AF OUTPUT BAL (XLR, bal ) for the
output signal of the receiver unit CH 1 and the
output signal of the receiver unit CH 2, for con-
nection to two balanced microphone inputs,
e g of a mixer or amplifier
15 Control SQUELCH* to adjust the threshold for
noise suppression
16 Output of the master signal of the two receiver
units CH 1 and CH 2 (6 3 mm jack, unbal ) for
connection to a line input e g of a mixer or
amplifier
17 Power supply jack for connection of the sup-
plied power supply unit
A and B : indicate