Publicidad
Idiomas disponibles
Idiomas disponibles
8. Reinstall the brushroll back into the floor nozzle by placing end caps into slots.
First align the end cap of belt side of the brushroll with the slot and insert it into
place. Then press down the end cap of the non-belt side firmly into the slot as
shown below. Rotate the brushroll to make sure the belt is installed correctly.
NOTE: Make sure the belt is in the middle of the belt path as shown.
1
End Cap
9. Reinstall the lower plate by aligning tabs on front edge of lower plate with slots
in the nozzle first, and then press the lower plate into installed position.
NOTE: Check to make sure the small wheel bracket is properly fixed by the lower
plate and cannot be lifted off.
10. Reinstall six screws into the lower plate. Do not over-tighten the screws.
2
End Cap
√
-24-
Small Wheel Bracket
Publicidad
