Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Be sure the fan is in the OFF position.
Place your fan on a dry, level surface.
Plug the power cord into a polarized 120 volt AC wall outlet.
To operate, turn the control knob to the desired fan speed: HIGH (III), MEDIUM (II) or
LOW (I) (Fig. 4).
Adjust the fan to the desired angular air output direction.
To move the fan, turn the fan OFF and pick it up by the concealed handle that is located
on the outside rim of the fan (Fig. 5).
WALL MOUNTING (HT-900 AND HPF820 SERIES ONLY)
DO NOT mount on a ceiling.
Locate and mark the position on the wall where the fan will be mounted (preferably at a wall stud).
Insert two screws into the wall stud. (Screws are not included and can be purchased at a hardware store).
Use #8, 1˝ length screws, leave 3/8˝ below screw head (bolt) exposed from the wall.
Line up the openings on the base of the fan with the screws (bolts) and hang the fan on the wall.
NOTE: HF-910 Series and HT-908 Series cannot be wall-mounted
CLEANING AND STORAGE
Unplug the fan before cleaning.
• Use only a soft, damp cloth to gently wipe the fan clean.
• DO NOT immerse the fan in water and never allow water to drip into the motor housing.
• DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
Removal of the grille for cleaning
DO NOT REMOVE THE FAN GRILLE UNLESS THE POWER IS
TURNED OFF AND THE POWER CORD IS UNPLUGGED.
• Gently lay the fan face down on a table (Fig. 6).
• Screws are located in the holes around the back grille of the fan (Fig. 7).
• After the screws in each hole are located, insert a standard Phillips Head
screwdriver
into one of the screw holes.
NOTE: Screwdriver head should fit comfortably in the hole without being too tight or
leaving too much room. A screwdriver with a head that is too small will have trouble
engaging the screw.
• Each screw should be engaged and loosened by unscrewing each head to the left.
• Once all screws have been loosened, slowly lift the fan up off the surface using the
back carrying handle, and separate the front grille along the seam where the screws
were located (Fig. 8).
4
4
4
5
6
7
8
Fig. 10
Publicidad
