Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the system outer foil
(see fig. 7)
Squeeze the system outer foil re-
fease buttons and lift the system
outer foil upward to remove it. To in-
sert the new system outer foil, press
down until it snaps into place.
Replacing the inner blades
(see fig. 8)
Squeeze the foil frame release but-
tons and lift the foil frame upward to
remove it. Remove the inner blades,
one ata time, by grasping them firmly
at both ends and pulling straight
away from the shaver. To insert the
new inner blades, hold the blades,
one at atime, at both ends and press
downward until they snap into place.
ATTENTION:
A nickel metal hydride battery(s)
that is recyclable powers the prod-
uct you have purchased. Please
Call 1-800-8-BATTERY for informa-
tion on
how
to recycle
this
battery(s).
How
to
remove
the
built-in
rechargeable battery(s) betore
disposal of the shaver
{see fig. 9)
The procedure described below is
intended only for removal of the re-
chargeable battery(s) for the purpose
of proper disposal.
1. Remove the two screws (a).
2. Pull the chassis (b) out of the
housing.
3. Turn the chassis over and remove
the battery{s) (c).
WARNING:
Do not attempt to replace the
battery(s) for the purpose of reus-
ing the shaver. This could result in
the risk of fire or electric shock.
Caution
* Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
Use only the included shaver
charging adaptor RE3-93 to charge
the ES8036 shaver.
The supply cord of the charging
adaptor cannot be replaced; if the
cord is damaged, the entire charger
should be discarded.
Dry the shaver completely before
setting it in the charging adaptor.
Keep the charging adaptor away
from water and handle it only with
dry hands. Do not use an extension
cord to connect the charging adap-
tor to an outlet.
The shaver may not immediately
begin to charge after being placed
into the charging adaptor after use.
Allow the shaver to sit in the charg-
ing adaptor for a tew minutes and
check again to make sure that it is
being charged.
Do not place any metal objects like
coins and paper clips on the charg-
+
kd
Publicidad
