Publicidad
Idiomas disponibles
Idiomas disponibles
aligned.The small hole on the separating piece should correspond to the
fixed pin position on the separating bowl base.
c.The disc with bump must be installed at the bottom,the other disc could
be installed in any order.
d.When installing the separating piece, the one with small convex points on
the separating piece surface shall be placed at the bottom.Other
separating pieces can be installed at will.
e.The nut must be tightened.
Special note:
①This part must be kept well to avoid the deformation caused by
careless drops in the process of use and cleaning,which will affect the
product noise and separation effect
②In order to prolong the service life of the product, please wipe it with a
dry cloth after each use and cleaning to keep it clean and dry.
V.Common Faults and ELIminating Methods
Fault
Conditions
Poor Separation
Performance
Causes
1.Milk temperature is too low
or too high.
2.Milk is too sour.
3.Milk is not clean.
4.The nut is not tightened and
the separating piece is not
clamped.
- 9 -
Eliminating
Methods
1.Adjust the milk to
35℃-45℃.
2.It cannot be
separated.
3.Filter milk.
4.Tighten the nut.
Publicidad
