VEVOR NNJ-F50 Manual Del Usuario página 8

2)Align the hole at the bottom of the "Separation pumps" with the electric
separator . The "Snap" sound when the "Separation pumps" is tightened
indicates that it has been fully installed.
3)Press tightly and tie the "Milk trough" and the "Oil flow sump" to the
"Separation pumps"below. The cream mouth can be twisted at will.Ensure
the "Oil flow tank seat" is placed between the Milk trough and the Oil flow
sump.
4)Install the "Funnel seat" . This allows the milk from "Milk pot" to flow into
the "Separation pumps" for separation initially.
Next, position the "Buoy" to allow the milk to gradually flow in batches into
"Funnel seat", preventing any overflow or leakage from too much milk.
5)Place the "Milk pot".
6)Finally, insert the "Switch core". When rotated counterclockwise, the milk
flows into the separation pump for processing. Rotate it clockwise to halt
the milk flow, pausing the separation process.
II.Operation Steps
The operation steps are as follows:
1)Place the product on a flat surface to ensure effective milk separation.
2)Pour about one third of the 60°C water into the milk pot container
3)Put the power on and switch on the separator to make the motor work
4)After the separator works for 1 minute, slowly turn the milk container
- 6 -