Publicidad
Idiomas disponibles
Idiomas disponibles
No Butterfat
The butterfat is
too thin or the
fat hole gives
milk
The separator
overflows or the
hole leaks a lot
of milk
1.The height of the separating
bowl is not correct.
2.The butterfat outlet hole on
separating cover is blocked.
3.The small hole on the
separating piece does not
correspond to the fixed pin
position on the base of the
separating bowl.
4.The butterfat outlet hole on
the separating cover shall not
be exposed from the middle
of the gap of the separator
bowl cover.
5.The cream is too thick.
1.The butterfat is too thin.
2.The height of the separating
bowl is not correct.
1.At the beginning of the
work,the metal rod was too
open.
2.The nut is not tightened.
3.The seal ring is improperly
installed or damaged.
4.The height of separating
bowl is too low.
- 10 -
1.Adjust the height of
the separating bowl.
2.Dredge the fat
outlet hole.
3.Reinstall the
separating bowl and
align the pin.
4.Refit the separating
bowl.
5.Adjust the screw
and turn it to the right
1.Adjust the screw
and turn it to the left.
2.Adjust the height of
the separating bowl.
1.Turn down the
metal rod and
gradually increase it
after normal
operation.
2.Tighten fully.
3.Reinstall or
replace.
4.Adjust the height of
the separating bowl.
Publicidad
