Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY & INSTALLATION
Before connecting the appliance to a power source, let it stand upright for
approximately 24 hours. This will reduce the possibility of a malfunction in
the cooling system from handling during transportation.
This beverage fridge is a freestanding unit and should not be built into surrounding
cabinetry. Allow for proper air clearance around the fridge. The recommended
clearances are as follows:
Sides: 4.5"
Top: 4"
Back:4"
Before operating your beverage fridge for the first time, follow these steps:
1.
Allow the unit to sit upright for 24 hours prior to first use. Upon the first use, allow
the unit to sit at the desired temperature for at least 30 minutes before changing
settings or filling it with drinks.
2.
Clean the interior surface of the unit with warm water and a soft cloth.
3.
Handle the unit with care. Do not apply force to any parts, such as the condenser or
the door. The metal rails on the bottom of the unit may be sharp, so please use
caution when moving the unit. Do not tilt the unit beyond 45 degrees or drag it
across the floor.
4.
Place the fridge on a level surface that will be strong enough to support the unit
when it is fully loaded. To level your fridge, adjust the front feet located at the
bottom of the unit. If the unit is not level, the doors and magnetic seal may not
work properly. (Please note that placing your fridge on carpet may result in
expelled heat fading the carpet.)
5.
Install the fridge away from direct sunlight and heat sources such as stoves,
heaters, or radiators. Direct sunlight may affect the unit's acrylic coating, and
nearby heat sources can increase electrical consumption. Extreme cold or hot
ambient temperatures may also prevent optimal performance.
www.newair.com
EN
11
Publicidad
