Publicidad
Idiomas disponibles
Idiomas disponibles
LEVEL WASHER
IMPORTANT:
Level washer properly to reduce excess noise
HELPFUL TIP: You may want to prop up front of washer about
and vibration.
A" (102 mm) with a wood
block or similar object that will support
weight of washer.
AWARNING
Excessive Weight Hazard
Models with
plastic feet
Use two or more people to move and install washer/dryer.
Failure to do so can result in back or other injury.
1.
Move the washer to its final location. Place a level on top
edges of washer. Use side seam as a guide to check levelness
of sides. Check levelness of front using lid, as shown. Rock
washer back and forth to make sure all four feet make solid
contact with floor.
Models with
metal feet
3. On models with metal feet, when washer is level, use a
9/16" or 14 mm open-end or adjustable wrench to turn jam
nuts counterclockwise on leveling feet tightly against washer
cabinet.
Not Level
LEVEL
Not Level
2. On models with metal feet, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer.
On models with plastic feet, use adjustable pliers to turn the
plastic leveling foot counterclockwise to lower the washer or
clockwise to raise the washer. On all models, recheck levelness
of washer and repeat as needed.
INSTALLING COIN SLIDE AND COIN BOX
The coin slide mechanism, service door lock and key, and coin box
lock and key are not included with some models, but can
be obtained from the usual industry sources.
Remove the service door of the meter case by lifting it up at the
back. Install the money-accepting device. (Refer to manufacturer's
instructions for proper installation.)
For washer using coin slides, use the adapter kit supplied with the
washer.
Install a lock and cam on the meter case service door. Install the
coin vault with lock and key in the meter case opening.
12
Publicidad
