probst TSZ-UNI Instrucciones De Uso página 56

Maintenance and care
Rubber gripper bar
Regular control for dirt (e.g. little stone particles) in the upper area (see points in figure detail „X" in Fig.
2) of the rubber gripper bar (6) → see Fig. 1 / Fig. 2
Problem: Dirt can damage the rubber gripper bar (6) when gripping (when little stone particles are
pressed into the rubber gripper bar).
Redress: Remove the dirt in this area at the rubber gripper bar (6), or when heavy polluted, dismount
and clean the rubber gripper bar.
7.1.2 Additional with steelfinger grippers (WB-SQ)
Before each start-up:
Regular:
Weekly:
AUTOMATIC-RELEASE
Never grease or oil the automatic-release!
Clean with high-pressure cleaner when the automatic-release is dirty.
53100338
Fig. 1
•
Check all steelfinger grippers for mobility, abrasion and contamination.
Worn (no longer sharp-edged) or bent steelfinger grippers must be replaced!
•
Cleaning of the device with high pressure cleaner (warm water).
•
Lubricate and oil mobile parts
23 / 26
Fig. 2
GB