Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
Do not look in the light or see the source of light
•
directly.
Pull the switch lever/trigger to light up the lamp. The
lamp keeps on lighting while the switch lever/trigger is
being pulled.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the saw blade
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade, blade clamp and/or slider.
Failure to do so may cause insufficient tightening
of the blade, resulting in a serious injury.
For Model RJ01
1
012161
Insert the recipro saw blade into the blade clamp as far
as it will go. The blade clamp sleeve rotates and the
saw blade is fixed. Make sure that the saw blade cannot
be extracted even though you try to pull it out.
CAUTION:
If you do not insert the saw blade deep enough,
•
the saw blade may be ejected unexpectedly during
operation. This can be extremely dangerous.
NOTE:
You can not use the jig saw blade with RJ01
•
1
2
012162
1. Recipro saw
blade
2. Blade clamp
sleeve
2
1. Blade clamp
sleeve
2. Saw blade
To remove the saw blade, rotate the blade clamp sleeve
in the direction of the arrow fully. The saw blade is
removed and the blade clamp sleeve is fixed at the
released position.
NOTE:
If you remove the saw blade without rotating the
•
blade clamp sleeve fully, the sleeve may not be
fixed. In this case, rotate the blade clamp sleeve
fully, then make the sleeve fixed at the released
position.
For Model RJ02
3
4
2
012165
1
3
1. Recipro saw blade
2. Hex wrench
3. Hole for recipro saw blade
4. Blade clamp
013062
To install the saw blade, loosen the bolt by hex wrench.
When installing a recipro saw blade, press the bolt with
the hex wrench to open the slot during inserting the
blade.
6
1. Hex wrench
1
2. Bolt
3. Loosen
4. Tighten
2
4
Publicidad
