Conditions of use of this electrically assisted bicycle
This electrically assisted bicycle is designed for urban and peri-urban use, it allows you to move around
town, on the road or on a paved surface where the tires are always in contact with the ground. It is
equipped with electric pedaling assistance which will make all your daily trips easier, to go further and
for longer. Your electric bike is an adult bike, for people over 14 years old. In the event that the bicycle
is used by a child, the responsibility is with the parents and must ensure that the user is able to use
the bicycle safely.
Your bike is not intended for use on unpaved or rough terrain. It is not designed for ''all-terrain'' use,
nor for competition. Failure to comply with this practice may result in a fall or accident and may
prematurely and potentially irreversibly deteriorate the condition of your electric bike.
Your e-bike is not a moped. The purpose of the assistance is to provide a complement to the pedalling.
The moment you start pedaling, the motor kicks in and helps you in the effort. The assistance varies
according to the speed of the bike, high at start-up, less sustained when the bike is launched then
disappears when the bike reaches 25 km/h. The assistance is cut off as soon as one of the two brake
levers is actuated or the speed is greater than 25 km/h. This will resume automatically below 23 km/h
with pedalling.
It must be properly maintained according to the instructions in this manual.
WARNING: Like any mechanical component, a bicycle is subject to high stress and wear.
Different materials and components may react differently to wear or fatigue. If the
expected lifespan of a component has been exceeded, it may break suddenly, risking
injury to the cyclist. Cracks, scratches and discoloration in high stress areas indicate that
the component has exceeded its life and should be replaced.
Recommendation: Safe and secure use
Before using your e-bike, make sure it is in good working order. Check the following points in
particular:
•
Position should be comfortable
•
Nuts, screws, clamping levers, clamping components
•
The brakes are in working order
•
The handlebar travel is good without too much play, the handlebar is correctly fixed to the
stem
•
Wheels are unobstructed and bearings are properly adjusted
•
The wheels are properly tightened and attached to the frame/fork
•
The tires are in good condition and their pressure is good.
•
The condition of the rims
•
The pedals are firmly attached to the crankset
90