Trumpf TruTool TPC 165 Manual Del Usuario página 11

DANGER
Cuts injuries on the saw blade
Do not reach into the saw area with
u
your hands, or touch the saw blade or
the area below the workpiece.
Never hold the workpiece in your hand
u
or over your leg. Always secure the
workpiece on a stable support.
Only hold machine on insulated han-
u
dles when machining.
u When cutting lengthwise, always use a
stop or a straight edge guide.
DANGER
Risk of injury due to inhaling dust
Ensure good ventilation in the work-
u
place.
u If necessary, wear respiratory protec-
tion.
Never cut boards that contain as-
u
bestos.
Use extraction in order to protect the
u
operator against particles that are haz-
ardous to health and keep the work en-
vironment free of dust.
WARNING
Danger of injury or property dam-
age due to use of third-party acces-
sories
Only use original TRUMPF acces-
u
sories.
ATTENTION
Property damage due to excessive
power supply voltage
Make sure that the power supply volt-
u
age matches the details on the power
tool's nameplate.
Translation of the original operator's manual
1.3 Symbols
The following symbols are important for
reading and understanding the operator's
manual. The correct interpretation of the
symbols helps to operate the power tool
properly and safely.
Sym-
Description
bols
Type of panel cutter
TPC 165
TruTool TPC 165 (2A1)
(2A1)
Power tool with power cable
Lubrication
Cleaning the surface
Inspection
Top up oil
Hold down
Loosen / tighten the hexagon-head
screw
Loosen the hexagon-head screw
slightly
Loosen / tighten the slotted screws
Read operator's manual
Disposal/recycling of old devices
and batteries
Li-ion
EN
11