Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3 Operation
WARNING
Overload of the hands due to vibra-
tions when piercing the workpiece
Only apply the machine to the work-
u
piece once it has reached full speed.
When piercing the workpiece, hold the
u
machine tightly with both hands.
ATTENTION
Wear and destruction of the saw
chain and the blade, failure of the
machine
Do not tension the saw chain too
u
tightly.
When inserting the saw chain, pay at-
u
tention to the direction of the saw teeth.
Always use saw chain with lubrication.
u
Prevent collisions with nails and
u
screws.
To operate the power tool, see:
– Tensioning/loosening saw chain
[} 230].
A
– Filling the oil tank, testing the oil delivery
[} 230].
B
– Switching on
– Switching off
– Setting the immersion depth
– Cutting panels
– Inserting into panels
– Cutting internal cut-out
– Using a guide rail
– Mounting the extraction
– Changing the saw chain, cleaning the
blade
[} 233].
K
– Changing sliding rails
– Changing wearing plate
– Changing the front wearing plate
[} 235].
N
– Setting the trigger
14
[} 230].
C
[} 230].
D
[} 231].
E
[} 231].
F
[} 231].
G
[} 232].
H
[} 233].
I
[} 233].
J
[} 235].
L
[} 235].
M
[} 236].
O
Translation of the original operator's manual
3.1 Main machine position
The machine is lying with the support sur-
face flat on the material and the blade is
pointed vertically downward.
90°
3.2 Table markings
For a straight cut, the cut markings must be
aligned on the planned cut.
1
2
1
Front cut marking
2
Rear cut marking
3
Insertion position
4
Front side of blade
5
Rear side of blade
5
4
3
Publicidad
