GE Profile OPAL P4INSASBVTS Manual Del Propietário página 7

Making Ice with Opal
first use.
1. Open the lid to access the lower water reservoir.
2.
If using tap water, the unit will need to be descaled more
often (every 2-3 weeks) to maintain proper function.
3. Plug the ice maker into a grounded outlet.
NOTICE
Understanding the Display
Making Ice
Power
The Power button, when pressed, will activate the machine
controls, and begin the ice making process. When the
machine is active and ON, the Power button, when
Cleaning
The cleaning cycle is initiated by pressing and holding the
cycle, simply press and hold the Clean button again.
After 100 hours of ice making, the Cleaning indicator will
Ice Scoop Storage
49-9000060 Rev. 0
Add Water Cleaning
descale cycle is needed.
4. Touch the Power button to start the ice maker. The indicator
unit has begun to make ice.
continue to make ice until the bin is full, or it runs out of water.
To continue making ice, remove ice from the ice bin or add
more water.
Clean
Defrosting
Hold 3 Sec
Defrosting
unit will run a rinse cycle to defrost the ice maker and then
start making ice again.
Indicator Lights
Water is highlighted, your unit needs more water before it
can cycle to make ice or clean.
Power
7